A good sand making machine has a high utilization rate of sand and stone. However, how to choose a good quality sand making machine, how to equip a complete set of sand making production line, and how to operate correctly if configured? These problems are still closely concerned by our sand making industry. As a domestic manufacturer of world-class high-performance crushing equipment, SMMVIK Machinery is very important to standardize the use of equipment.
1. Generally, we need to check whether the machine is damaged before using any equipment. If the stone of the whole part is damaged during transportation, we should check whether the observation door of the whirling crushing chamber is closed tightly before using the sand making machine, so as to prevent materials from rushing out of the observation door of the whirling chamber and causing danger.
2. Check the rotation direction of the impeller from the direction of the feeding port of the sand machine. The impeller should roll counterclockwise, otherwise the wiring of the electric motor should be adjusted.
3. The feeding particles of the sand making machine shall be strictly in accordance with the delimitation requirements. It is forbidden to enter the crusher with materials larger than the delimitation. Otherwise, it will cause the imbalance of the impeller and excessive wear of the impeller, so as to block the impeller channel and feeding pipe, so that the crusher cannot work normally. If too large materials are found to enter, they should be eliminated in time.
4. The starting sequence of the sand making machine and the supporting conveying equipment is: first the discharge equipment, then the sand making machine, and finally the feeding equipment. The crusher must be started with no load, and the material can be fed only after the crusher runs normally. The shutdown sequence is the opposite of the startup sequence.
5. The feeding of the sander shall be continuous and uniform. During the operation of the crusher, there should be no violent vibration and abnormal noise, otherwise, it should be stopped for inspection.
6. In the process of use, it is necessary to carry out regular maintenance and repair, and do not neglect equipment maintenance after long-term use. If we wait for problems to be solved, the corresponding human and material costs will be higher.
7. Operators should pay attention to strictly follow the operating specifications of the sand making machine for production. When there are unbreakable materials in the sand making machine, it should stop running and remove them before production. At the same time, when the equipment is started, ensure that there is no material in the crushing chamber of the equipment, so that the equipment cannot be started with load.
8. When the sand making machine is about to end its work, it should cut off the power supply, just in case, and stop the machine after confirming that the materials inside the equipment are completely removed.
The production efficiency of the sand making machine is also closely related to the quality of the equipment. We should not only pay attention to the standardized operation in the production process, but also combine the performance advantages of the sand making machine. The VSI sand making machine of SMMVIK Machinery has good quality, low energy consumption, unique design, relatively easy maintenance, thin oil lubrication, reduced manpower, and is equipped with a self circulation system. These advantages play an obvious role in improving the efficiency of the sand making machine.
