SMMVIK Machinery vertical mill is mainly used for ultra-fine crushing of various non-metallic mine raw materials, such as loose iron ore, sandstone, gypsum, blast furnace slag, coal gangue, lump coal and other medium and hard ores. Due to different hardness, the wear of parts and components of the equipment for grinding ore is deeper. How to protect the vulnerable parts of the pulverizer and reduce the loss of the pulverizing equipment of the whole process?
In the grinding process of ore, the ore with high hardness is finely ground into powder with different particle sizes, which will lead to serious wear of the machine. However, we may think of using the method of replacing vulnerable parts to solve it, but if we frequently replace wear-resistant parts, it will increase the input cost of the equipment. Therefore, it is very important for users to choose a suitable stone mill, and the maintenance of parts and components should be done to reduce losses, Pay attention to the following points:
1. The model of the pulverizer matches the particle size of the ore material.
Good mill equipment has strict requirements for the particle size of ore feeding. As for the vertical mill, the size of the materials added must be appropriate. If the particle size is small, it can not fully play the function of the equipment. If the feed particle is too large, it will block the feed inlet. Our previous customer had this situation. Due to the lack of in-depth understanding of the pulverizer, it not only affected the normal production, but also damaged the impeller of the equipment. It is necessary to clean up the unprocessable materials in time to reduce the loss.
2. The lubrication of the pulverizer should be in place.
For the equipment grinding ore resources, regular lubrication is an important step in maintaining the equipment. If the equipment is not maintained in time, the wear of vulnerable parts will become more and more serious. Don't wait until it is irreparable to remember that I want to protect these parts. Therefore, after using the equipment for a period of time, be sure to check its wear and add appropriate lubricating oil according to the actual needs.
3. Tighten the screws of the parts and components of the mill in time.
Many parts of the mill are fixed by screws, and the movement of the equipment is often fierce when working. After a long time, these screws are easy to loosen, which makes the equipment ring abnormally in the process of working. Once the equipment has abnormal conditions, it should be shut down in time, and check whether the screws are loose. If so, it should be tightened in time.
SMMVIK Machinery ore vertical mill has the advantages of high efficiency, low energy consumption, small floor area and no environmental pollution. It is suitable for processing various non flammable and explosive minerals with Mohs hardness below 7 ,humidity below 6%, such as gypsum, talc, calcite, limestone, marble, potassium feldspar, barite, dolomite and other materials. Therefore, it is widely used in the grinding and processing of mineral products and materials in metallurgy, building materials, chemical industry, mining and other good areas. When choosing a mill, it is best to choose a larger professional manufacturer's equipment, collect more relevant information about the pulverizer manufacturer, and strive to reduce costs and losses.
