With the development of urbanization, sand making equipment is widely used in all aspects of our daily life. But many people don't know it very well. They think that the more materials the equipment feeds during operation, the better. Is that true? Let's have a look.
1. The blockage of the sand making machine may be due to the high feed speed. When the feeding speed is too fast, the load of the equipment will increase, and the materials that cannot be processed in time will be slow or even discharged. In this case, always pay attention to the feeding speed and the pointer of the ammeter of the sander equipment.
2. When the feeding amount is large, the current flowmeter pointer of the sand making machine equipment will be too large. When the rated current of the equipment is exceeded, it will lead to overload. In this case, the operation time is too long, which may cause the motor to block or even burn the equipment. When this happens, on the one hand, the feed speed should be reduced immediately and can be adjusted by adjusting the feed device. When selecting equipment, appropriate equipment must be selected to ensure that the sand making machine can work normally during the production process.
3. When the sand making machine equipment works for a period of time, problems such as aging, damage, screen closing, parts damage may occur, or when the water content of the materials broken by the sand making machine equipment is large, the equipment may slowly discharge or even prevent the materials. In this case, it is necessary to regularly inspect the equipment, timely maintain and replace the relevant accessories of the sand making machine to ensure the stable operation of the equipment. Under normal conditions, the moisture content of the crushed and crushed materials of the sand making machine shall be controlled below 14. After working for a period of time, the equipment shall be maintained and repaired.
In order to ensure the normal and stable operation of the sand making machine during operation, it is necessary not only to adopt correct operation steps, but also to regularly maintain and cultivate the equipment, so as to prevent problems.
