Diabase is an ideal building material, a basic hypabyssal intrusive rock. Diabase after processing and crushing can be used as an important aggregate for housing construction, highway, railway and other projects, so the crusher is a very important equipment.
HPT cone crusher adopts a better combination of crushing frequency and eccentricity, so that the content of fine particles in crushed products is higher. Therefore, the effect of more crushing and less grinding is more obvious, reducing the comprehensive power consumption of crushing and grinding.
The combination of high crushing frequency and crushing cavity makes its output higher than that of other types of crushers, greatly improves the laminated crushing effect between material particles, and makes the crushed products into even cubes. The use of hydraulic insurance, hydraulic locking, hydraulic adjustment and hydraulic cavity cleaning makes the operation more convenient and easy to realize automation.
At the same time, it is easy to maintain. This series of cone crusher with optimized design has low equipment failure rate and equipment operation rate of more than 85%, which significantly reduces the comprehensive cost of the crusher. It is a very ideal diabase crusher.
Performance characteristics of HPT hydraulic cone crusher:
1. Unique optimized structure, unique crushing principle and multi-point layered hydraulic system.
2. It has the characteristics of good stone quality, high efficiency, large production capacity and stable overall performance.
3. Reasonable structure, crushing principle and technical parameters, reliable operation.
4. The hydraulic system is convenient and reliable, and can provide safe and effective overload protection.
5. A variety of crushing chambers, to meet the requirements of a wide range of product size.
6. Hydraulic adjustment and hydraulic cavity cleaning are adopted to greatly improve the degree of automation.
Working principle of HPT cone crusher:
During operation, the motor drives the eccentric sleeve to rotate through the V-belt, transmission shaft and bevel gear pair. And the moving cone rotates and swings under the action of the eccentric sleeve to make the moving cone and fixed cone close and deviate from each other. The materials are crushed due to continuous extrusion and impact in the crushing chamber, and the crushed materials are discharged from the lower part.
Precautions for operation The following factors will reduce the production capacity of the hydraulic cone crusher:
1. Fine materials smaller than the discharge port in the feed exceed 10% of the crusher's production capacity, and the feed contains viscous materials.
2. The feed distribution around the crushing chamber is uneven, and the material is too hard or tough.
3. The screening capacity of the system is insufficient, and the discharge area of the crusher is blocked.
