The pure kaolin is white, fine and soft, with good plasticity, fire resistance and other physical and chemical properties. Kaolin has high industrial value and is often used as papermaking, ceramics and refractory materials, followed by coatings, rubber fillers, enamel glaze and white cement raw materials. The grinding machine for kaolin processed by SMMVIK Machinery is of high quality and is worth using by users.
For the selection of kaolin grinding machine, SMMVIK Machinery LUM ultra-fine vertical grinding machine can be considered, because this model is mainly used for grinding kaolin to obtain kaolin fine materials. With the wide application of kaolin superfine vertical mill, there are more and more factories producing kaolin mill in the market, which also attracts many buyers of kaolin mill. Some of our customers use our high-quality vertical mill to further process kaolin to improve its value and obtain greater profits.
What are the advantages of the milling machine for processing such high industrial value kaolin?
1. The rotating speed of the main engine is regulated by frequency conversion, which is applicable to a wide range of materials.
2. Due to the principle of ultra-fine grinding and multi wheel powder selection, when producing products with the same fineness, the energy consumption is saved by 30% - 50% compared with the ordinary mill, and the economic benefit is good.
3. Using PLC / DCS automatic control of grinding roller pressure control, the grinding pressure can be accurately controlled without manual operation.
4. A separate lubrication station is used for the lubrication of the grinding roller, and the single grinding roller circuit adopts the mode of double pumps and simultaneous pumping.
5. The grinding roller bearing can be fully lubricated and cooled, and the grinding roller bearing chamber will not leak due to excessive oil storage.
6. It is easy to maintain, and can be replaced in a very short time by repairing the oil cylinder, turning the boom, roller sleeve and lining plate.
7. The product quality is stable and the particles are evenly distributed. The material stays in the mill for a short time, which is easy to detect and control the particle size and chemical composition of the product, and the product quality is stable.
